...................................................................................................................................................................................................
25
Click Alarms. The Alarms List is displayed. The SWUPGCOMMIT alarm should not be
present in the Alarm List.
If... Then...
the SWUPGCOMMIT alarm is raised, continue with Step 26.
the
SWUPGCOMMIT alarm is not raised, STOP! You are done with this procedure.
...................................................................................................................................................................................................
26
Select Administration > Software > Upgrade.
Result: The Software Upgrade window is displayed.
...................................................................................................................................................................................................
27
In the Action field, select Commit.
...................................................................................................................................................................................................
28
Click Apply.
...................................................................................................................................................................................................
29
Click Alarms.
Result: The Alarms List is displayed. The SWUPGCOMMIT alarm should not be
present in the Alarm List.
To Replace a Simplex Equipment Controller Using CLI
...................................................................................................................................................................................................
1
Ensure that you are working with a valid database. Set up the database server information.
Type each command line, and press Enter:
1. Type
database server config.
2.
config database server ip IP Address, using the IP address where the
database is stored.
3.
config database userid, then enter your user ID and password when prompted.
4.
config database path directory with the path on the PC where the database is
saved.
5.
config database detail to verify your IP address, user ID, and path.
...................................................................................................................................................................................................
2
Backup the database by typing:
Supporting procedures
Replacing System Components
Replacing an Equipment Controller in a Nonredundant Shelf
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-46
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
