Need help?Do you have a question about the Alcatel-Lucent 1830 PSS-4 and is the answer not in the manual?
General| Interfaces | Ethernet |
|---|---|
| Supported Protocols | Ethernet, OTN |
| Power Supply | Redundant power supplies |
| Management Interface | Command Line Interface (CLI), Simple Network Management Protocol (SNMP) |
| Operating Temperature | 0°C to 45°C |
Describes the chapter's purpose: an alphabetical listing of alarm conditions with summary information.
Details the AIS condition for lines and MS, noting it's non-reportable and requires manual retrieval.
Explains the defect where all channels are missing, typically due to C-Band loss of signal.
Covers Loss of Signal alarms, indicating low optical power at port input.
Introduces the chapter's focus on clearing conditions for the 1830 Photonic Service Switch.
Provides critical safety information related to procedures that may cause service disruption.
Troubleshooting steps for Card Failure - Device alarms.
Procedures for addressing Ethernet link down conditions.
Explains procedures for manually caused abnormal conditions (maintenance).
Procedures for handling card missing conditions.
Troubleshooting steps for failures during software upgrades.
Procedures for viewing and configuring alarms.
Step-by-step guide for safely reseating a card in the system.
General procedures for replacing various hardware components.
Overview of loopback tests and variations supported by OT cards.
Procedures to diagnose and resolve high temperature conditions affecting cards.
To Next Page