Alcatel-Lucent 1830 PSS-32 - Ampdisabled

If the power is too low, verify that the fiber is not damaged or dirty, and clean or replace if
necessary.
...................................................................................................................................................................................................
7
If the problem is not resolved, then replace the card. Refer to “Replacing System
Components” (p. 3-20).
AMPDISABLED
AMPDISABLED (Amplifier Disabled)
The amplifier was disabled because of a temperature problem.
Severity Critical
Service affecting? Yes
Applicability A2325A, AHPHG, AHPLG, ALPHG, ALPFGT, AM2017B,
AM2125A, AM2125B, AM2325A, OSCT
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
Trouble-clearing procedures
ALLCHANMISS-OUT
ALLCHANMISS-OUT (C-Band Loss of signal)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-29
E ND OF STEPS
...................................................................................................................................................................................................