Alcatel-Lucent 8950 AAA - Page 393

How to Configure for a TLS Demo Out of the Box8950 AAA Certificate Manager
............................................................................................................................................................................................................................................................
365-360-001R6.0
Issue 1, December 2008
22-25
............................................................................................................................................................................................................................................................
TLS_DH_DSS_WITH_AES_128_CBC_SHA
TLS_DH_RSA_WITH_AES_128_CBC_SHA
TLS_RSA_WITH_DES_CBC_SHA
TLS_DHE_DSS_WITH_DES_CBC_SHA
TLS_DHE_RSA_WITH_DES_CBC_SHA
TLS_DH_DSS_WITH_DES_CBC_SHA
TLS_DH_RSA_WITH_DES_CBC_SHA
TLS_RSA_EXPORT1024_WITH_DES_CBC_SHA
TLS_DHE_DSS_EXPORT1024_WITH_DES_CBC_SHA
TLS_RSA_EXPORT_WITH_DES40_CBC_SHA
TLS_DHE_DSS_EXPORT_WITH_DES40_CBC_SHA
TLS_DHE_RSA_EXPORT_WITH_DES40_CBC_SHA
TLS_DH_DSS_EXPORT_WITH_DES40_CBC_SHA
TLS_DH_RSA_EXPORT_WITH_DES40_CBC_SHA
TLS_RSA_EXPORT_WITH_RC2_CBC_40_MD5
TLS_DH_anon_WITH_AES_256_CBC_SHA
TLS_DH_anon_WITH_AES_128_CBC_SHA
compression_methods
NULL
Xmit: Access-Request
User-Name = "steve"
NAS-IP-Address = 127.0.0.1
NAS-Port = 1
Message-Authenticator = "00000000000000000000000000000000"
EAP-Message = "Response/EAP-TLS(2): flags=80(L)
msg.length=108frag.length=108"
State = "1"
Packet authenticator is valid
Recv: Access-Challenge after 80 ms.
Message-Authenticator = "C3A04508C76346818988A473A60DA9FF"
State = "2"
Session-Timeout = 180
EAP-Message = "Request/EAP-TLS(3): flags=C0(LM)
msg.length=1515
frag.length=1002"
Acking TLS fragment
Xmit: Access-Request
User-Name = "steve"
NAS-IP-Address = 127.0.0.1
NAS-Port = 1
Message-Authenticator = "00000000000000000000000000000000"
EAP-Message = "Response/EAP-TLS(3): flags=00()"