Alcatel-Lucent Halo H3P - Page 11

Copyright @ALE 2020 All Rights Reserved
11
The following table lists the parameters you can use to configure IP addressing mode.
Parameter
LocalEnetcfgIpstack
config.<mac>.xml
Description
It configures the IP addressing mode.
Permitted
Values
IPv4
IPv6
Default
IPv4
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Stack->IP Stack
If you change this parameter, the IP phone will reboot to make the change take effect.
The following table lists the parameters you can use to configure IPv4.
Parameter
LocalEnetcfgDhcpMode
config.<mac>.xml
Description
It configures the Internet port type for IPv4.
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv4.
Permitted
Values
Static
Dynamic
DynamicAlcatel
Default
Dynamic
Web UI
Network->IP parameters->DHCP Mode
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Config->IPv4
Settings-> IPv4 Mode
Parameter
LocalEnetcfgIpaddr
config.<mac>.xml
Description
It configures the IPv4 address.
Example:
LocalEnetcfgIpaddr= 192.168.1.20
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv4, and "
LocalEnetcfgDhcpMode " is phone to Static.
Permitted
Values
IPv4 Address
Default
Blank
Web UI
Network->IP parameters->IP Address
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Config->IPv4
Settings-> IP
Parameter
LocalEnetcfgSubnet
config.<mac>.xml
Description
It configures the IPv4 subnet mask.
Example:
LocalEnetcfgSubnet= 255.255.255.0
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv4, and "
LocalEnetcfgDhcpMode " is phone to Static.
Permitted
Values
Subnet Mask
Default
Blank