This configuration guide is written as a general guide on how to configure the Alcatel-Lucent
M7 phone model to work with PBXware 5.3.9 and 6.4.
Requirements
Identifying Phone Model
To start and successfully complete the registration of your Alcatel-Lucent phone, you need to
know which phone model to set up.
On the back of each Alcatel-Lucent phone, there is model information that you should check.
Although various phone models can have exactly the same requirements and installation
procedures, phone models can also have significantly different requirements and installation
procedures, so that is why it is important to know the model you own which results in you
setting up the device successfully.
Phone Firmware
Make sure that your phone is loaded with appropriate firmware version, 2.12.04.000.1720.
■
To find out the firmware version of the Alcatel phone model, open a new browser window and
■
enter the phone's IP address in order to access the phone's web administration interface login
screen. Example: http://192.168.1.22.
Log in to the phone's web administration interface with your username and password. Please
■
note that the factory default login details are as follows: username is admin and password is
123456.
To Next Page
Loading...
Need help?
General
