Alcatel-Lucent M7 - Find the Phones IP Address; Reset to Factory Settings; Registering Phone; Manual Configuration

Make sure the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.
Find the Phone's IP Address
Find out your Alcatel phone's IP Address.
Press the OK button.
■
The IP address will be displayed on the top of display.
Reset to Factory Settings
This step is not required for brand new out-of-the-box phones, however, if the phone has been
already used, then it is a must.
Click Maintenance in the left-hand navigation menu.
■
Click the Reboot&Restore sub-section.
■
Click OK next to the 'Restore Factory' field to initiate action.
■
Wait for some time for a device to reset to factory settings.
■
NOTE: Do not unplug or remove power from the phone while it is updating firmware and
configuration.
Registering Phone
This section describes how to identify the Alcatel phone model, requirements that must be met,
and how to register the phone using manual configuration or auto-provisioning.
The following topics are covered:
Manual Configuration
■
Auto Provisioning
■
Manual Configuration
This section describes how to set the UAD settings, create a PBXware Extension and register
the phone.
The following topics are covered:
UAD Settings
■
Creating an Extension
■
Registering a Phone
■
UAD Settings