You can connect a PC to this port to configure the Alcatel-Lucent PoE GA using a Command
Line Interface (CLI).
1.2.5 Power connector
This is used to accept power from a 48 V DC local power adaptor.
1.2.6 Power adaptor
This is used to supply 48 V DC from local wall power. Model name: FSP025-1AD207A
The connection to the Alcatel-Lucent PoE GA must comply with the following standard for
cable type: IEC320 C14.
The Alcatel-Lucent PoE GA is not supplied with country compatible cables. You must provide
specific cables separately.
1.3 Power consumption and cabling
The Alcatel-Lucent PoE GA consumes a maximum power of 12.95W when powered by a PSE
over Ethernet. An IP Phone consumes an average of 2-3W.
Chapter
1
1-2
To Next Page
Loading...
