EasyManuals Logo

Alcatel-Lucent OmniPCX Office User Manual

Alcatel-Lucent OmniPCX Office
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
- there is a problem with the fan (message 124)
- the hardware message table is 80% full (message 160); this alarm is only transmitted if the
"OperAlarm" flag is other than 0
- NMC: history event table 80% full (message 161)
- NMC: call detail record table 80% full (message 162)
- NMC: call detail record table full (message 166)
- IBS synchronization lost on UA link 0 (message 202)
- IBS synchronization lost on UA link 1 (message 203)
- the Ethernet interface of the IP-LAN board xxxx is out of service (message 221)
- the Ethernet interface of the IP-LAN board xxxx is in service (message 222)
- the duration of the VMU messages is reaching maximal duration (message 241)
- an error occurred at the opening of the voice prompt file (message 242)
- an error occurred at the reading of the voice prompt file (message 244)
- an error occurred at the writing of the voice prompt file (message 245)
- the downloading of an Alcatel-Lucent 9 series terminal has failed (message 252)
Chapter
6
% *
52/62
 ! "#$ ! % $& !     

Other manuals for Alcatel-Lucent OmniPCX Office

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniPCX Office and is the answer not in the manual?

Alcatel-Lucent OmniPCX Office Specifications

General IconGeneral
VoIP ProtocolsSIP, H.323
Power Supply100-240 VAC, 50/60 Hz
Humidity10% to 90% non-condensing
TypeIP PBX
Maximum TrunksUp to 60
Voice codecsG.711, G.729
Network Interfaces10/100 Ethernet
WeightVaries depending on the model/configuration

Related product manuals