August 2008 Unpacking Instructions 3
Items Included
Your OmniSwitch 6400 Series switch order includes the
following items:
• OmniSwitch 6400 Series chassis
• Power supply and power supply tray
• Rack mount flanges with attachment screws (rack
mount flanges may be pre-installed on some orders)
• Power cord (country-specific) and power cord bracket
• Product Documentation Card
• DB9 to RJ-45 serial adapter and console cable
Depending on the items ordered for your specific network
requirements, the following optional items may also be
included:
• SFPs/XFPs (per order)
• Backup power supply components and cables
(per order)
Unpacking the Chassis
To protect your OmniSwitch chassis and hardware compo-
nents from electrostatic discharge (ESD) and physical damage,
read all unpacking recommendations and instructions care-
fully before beginning.
Recommendations
• Unpack your OmniSwitch chassis as close as possible
to the location where it will be installed.
• Depending on your order, Small Form-Factor Plugga-
bles (SFPs) and backup power supply components may
be packaged separately. In order to greatly reduce
exposure to electrostatic discharge (ESD) and physical
damage, do not unpack these items until they are ready
to be installed.
Instructions
1 Carefully cut the tape along the seam at the top of the
box containing the chassis.
2 Lift the box’s top flaps. Remove any smaller boxes or
pouches that are enclosed and set them aside.
Unpacking Instructions
To Next Page
Loading...
