OmniSwitch 6850 Series Chassis and Hardware Components OmniSwitch 6850-48L
OmniSwitch 6850 Series Hardware Users Guide August 2007 page 2-9
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to page 2-56.
OmniSwitch 6850-48L Front Panel
10/100Mbps and 10/100/1000 Mbps
The OS6850-48L provides 44 fixed
10/100BaseT (5–48) and 4 fixed 10/100/1000BaseT
combo (1–4). These are auto-sensing and auto-MDIX and
use RJ-45 connectors.
Console Port
The OS6850-48L front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
Status and Slot Indicator LEDs
For detailed information on OS6850-48L
status and slot indicator LEDs, refer to page
2-54.
USB Port
High speed (480 Mbps) USB 2.0
port, which can be used for quick
upgrades.
Combo SFP
The OS6850-48L provides four combo SFP connectors for 1000Base-X high-
speed connections
.
By default, when an SFP is installed in a combo port, it takes over the port num-
ber of the corresponding RJ-45 Ethernet port. In other words, if an SFP is
installed in the slot labeled 4, Ethernet port 4 would no longer be available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
“preferred fiber.” Refer to “Configuring Ethernet” in the
Network Configuration Guide for detailed information, including steps for con-
figuring combo port settings.
OmniSwitch 6850-48L
USB
Console
OK
PRI PWR BPS
CLASS 1 LASER PRODUCT
1 2 3 4
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
To Next Page
Loading...
