OmniSwitch 6850-24 OmniSwitch 6850 Series Chassis and Hardware Components
page 2-24 OmniSwitch 6850 Series Hardware Users Guide August 2007
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to page 2-56.
OmniSwitch 6850-24 Front Panel
OmniSwitch 6850-24
USB
OK
PRI PWR BPS
Console
CLASS 1 LASER PRODUCT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
21 22 23 24
10/100/1000Mbps
The OS6850-24 provides 20 fixed 0/
100/1000BaseT non-combo (1–20)
and 4 fixed
10/100/1000BaseT combo (21–24).
These are auto-sensing and auto-
MDIX and use RJ-45 connectors.
Console Port
The OS6850-24 front panel pro-
vides one RJ-45 port for console
connections. Console connec-
tions are used by network admin-
istrators for switch management.
This female RJ-45 connector
provides a DTE console connec-
tion.
Status and Slot Indicator LEDs
For information on the OS6850-24’s
status and slot indicator LEDs, refer
to page 2-54.
USB Port
High speed USB 2.0 port, which
can be used for quick upgrades.
Combo SFP
The OS6850-24 provides four combo SFP
connectors for 1000Base-X high-speed con-
nections.
By default, when an SFP is installed in a
combo port, it takes over the port number of
the corresponding RJ-45 Ethernet port. In
other words, if an SFP is installed in the slot
labeled 24, Ethernet port 24 would no longer
be available and cannot be used for 10/100/
1000 traffic. This default setting is referred to
as “preferred fiber.” Refer to “Configuring
Ethernet” in the
Network Configuration
Guide for detailed information, including
steps for configuring combo port settings.
To Next Page
Loading...
