OmniSwitch 6850 Series Chassis and Hardware Components OmniSwitch 6850-P48
OmniSwitch 6850 Series Hardware Users Guide August 2007 page 2-43
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to page 2-56.
OmniSwitch 6850-P48 Front Panel
10/100/1000Mbps PoE
The OS6850-P48 provides
44 fixed 10/100/1000BaseT
non-combo PoE (5–48) and
4 fixed
10/100/1000BaseT combo
PoE (1–4). These are auto-
sensing and auto-MDIX and
use RJ-45 connectors.
Console Port
The OS6850-P48 front panel
provides one RJ-45 port for con-
sole connections. Console con-
nections are used by network
administrators for switch man-
agement. This female RJ-45 con-
nector provides a DTE console
connection.
Status and Slot Indicator LEDs
For information on the OS6850-P48’s
status and slot indicator LEDs, refer to
page 2-54.
USB Port
High speed (480 Mbps) USB 2.0
port, which can be used for quick
upgrades.
OmniSwitch 6850-P48
USB
OK PRI PWR BPS
Console
CLASS 1 LASER PRODUCT
1 2 3 4
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
Combo SFP
The OS6850-P48 provides four combo SFP connec-
tors for 1000Base-X high-speed connections.
By default, when an SFP is installed in a combo port,
it takes over the port number of the corresponding RJ-
45 Ethernet port. In other words, if an SFP is installed
in the slot labeled 4, Ethernet port 4 is no longer avail-
able and cannot be used for 10/100/1000 traffic. This
default setting is referred to as “preferred fiber.” Refer
to “Configuring Ethernet” in the Network Configura-
tion Guide for detailed information, including steps
for configuring combo port settings.
To Next Page
Loading...
