To Next PageTo Next Page
Need help?Do you have a question about the aldes InspirAIR H110-TF and is the answer not in the manual?
General| Type | Heat Recovery Ventilator |
|---|---|
| Voltage | 120 V |
| Airflow @ 0.2 in. w.g. | 110 CFM |
| Noise Level | 26.4 - 44.8 dBA |
| Supply Voltage | 120 V |
| Filter Type | MERV 8 |
| Power Supply | 120 V, 60 Hz |
| Sound Pressure Level | 26.4 - 44.8 dBA |
Details different ducting configurations for optimal system performance and airflow.
Guides on how to switch the unit from master to slave mode by moving a jumper on the circuit board.
Details the installation of the Humidity Control for managing excess humidity in the home.
Describes the installation of the 20/40/60 Minute Timer for controlling high-speed exterior exchange.
Explains the importance of airflow balance and the potential consequences of an unbalanced system.
Provides step-by-step instructions for measuring airflow using the door-port method with a pressure gauge.
Describes how to adjust motor speed and balance airflow using the FLEXControl interface and potentiometers.
Explains the in-duct balancing method using pitot tubes, airflow stations, or probes.
Explains how to balance airflow and adjust motor speed for ZRT-2 models with Constant Airflow Regulators.
Outlines the steps for balancing the ZRT VentZone® system, including setting flow rates and operating speeds.
Explains how to remove and clean or replace air filters based on their type.
Details how to remove, clean, and reinstall the recovery core, emphasizing safety precautions.
