26 27
Battery Charging
This lawnmower is equipped with electric start
and uses ALDI Xnity 20V powered batteries to
start the product.
Battery Model 51314 is provided with the product .
All Xnity 20V batteries are compatible including
model 55756.
The charger provided with this product is a
standard charger.
IMPORTANT: Before attempting to charge the
battery, check the battery charger adaptor (36),
plug pack charger (37), and the 51314 20V Xnity
Li-ion Battery (8) to ensure the charging equipment
matches the battery supplied. The components are
all labelled with component numbers.
NOTE: The 51314 20V Xnity Li-ion Battery (8) needs
to be removed from the lawn mower for charging.
CAUTION! The 51314 20V Xnity Li-ion Battery (8)
may require charging at rst use. A full charge will
require approximately 5-7 hours.
CAUTION! The working temperature of the
charging operation is 0°C to 45°C.
1. Connect the battery charger adaptor (36) into
the plug pack charger (37) (Fig O).
2. Connect the plug pack charger (37) in to the
240V mains power outlet. A “green” light
indicates power (Fig P).
3. Slide the battery charger adaptor (36) onto
the battery (8) by aligning the guiding rails.
A click indicates the battery is tted (Fig Q).
4. The plug pack charger (37) light will change to “red”. The battery is now in
the charging process.
When the light returns to “green”, the battery (8) is fully charged. (Fig P).
NOTE: The power to the charger should be turned o when unattended,
with or without a battery inserted.
Battery Charging Preparing for Operation
Mulch and Mowing
Using the mower without the hard catcher (13) attached, the lawn mower will
mulch as it cuts and and the ne grass clippings are distributed back onto the
grass surface without leaving piles of grass clippings.
WARNING:
Ensure the engine is NOT operating when undertaking this task.
1. Remove the hard catcher (13) by lifting the rear discharge guard and releasing
the hard catcher (13). (Fig R)
2. Lift the rear discharge guard (16), insert the mulching block (14) into
position by pushing in the right side then the left side, then engage the
2 x lock pins on the bottom of the mulching block with the 2 holes on the
bottom of the rear of the discharge chute, then release and close the rear
discharge guard (16) (Fig S).
NOTE: To remove the mulching block, you can only do so by taking the
left side out rst and then right side.
3. Ensure the side ejector cover (21) is in the closed position.
Do NOT use the side discharge chute (20) when mulch and mowing.
4. To remove the mulching block (14) after use, lift it up from the bottom,
then outwards to remove (Fig T).
Adding and Checking the oil
IMPORTANT: The engine of this lawn mower is packed with NO OIL in the
engine. Prior to starting the engine, oil MUST be added to the sump of
the engine.
Failure to add sucient oil will result in damage to the engine which is
NOT covered under the warranty of the lawn mower.
On a new lawn mower, the engine needs to be lled with 560ml of SAE 10W/30
engine oil. We recommend GARDENLINE® Full Synthetic 4 Stroke Oil.
Each time the lawn mower is used, the oil level should be checked and if low,
add sucient oil to ensure the oil level is to the full mark on the dipstick.
T.S.R.
O.
Q.
P.
CHARGING
POWER ON/FULLY
CHARGED
Preparing for Operation
To Next Page
Loading...
