40 41
Accessories and After Sales parts
Should you nd the following accessories are worn or past their user life,
replacements can be purchased online via our website www.extrabattery.com.au
If you have any queries regarding these accessories,
please call us on our Customer Support Line: 1800 909 909.
* Note that Xnity Battery 55756 is also compatible with this product.
Note that Xnity Charger 51323 is also compatible with this product.
1. Replacement
4 x Swing Blades
(59085-BL)
4. Replacement 20V Li-Ion
Battery (51314/A200)*
2. Replacement
Side Discharge Chute
(59085-SDC)
5. Replacement Mulching
Block (59085-MB)
3.
Replacement Charger
Base + Plug Pack Charger
(JLH122200370S / Z10)
6. Replacement
Spark Plug (LG F7RTC)
7. Replacement Air Filter
(59085-AF)
Warranty Troubleshooting
* blade mounting
plate not included
Problem
Possible Cause Solution
Engine does not start Fuel tank (25) is empty
Oil tank is empty
Spark plug (27)
Blades hitting the grass to be cut
Battery (8) is at
Check the fuel tank (25), and refuel if
required.
Check the level of the oil dipstick (24),
and if low or empty, add oil
Clean or replace if dirty or worn
Increase the cutting height of the mower
so the blades do not make contact with
the grass on start up
Charge the battery (8).
Cutting / Engine
performance
decreases
Cutting height
2 x blades (30) are dull or blunt
When using side discharge chute (20)
Hard catcher (13) is full
Increase the cutting height using the
8 height adjustment lever (18)
Replace the blades with new / sharp
blades.
Clean around the side ejector chute
NOTE: Always ensure the engine is turned
o before undertaking this task.
Empty hard catcher (13)
Hard catcher is not
lling up to optimum
level
Cutting height too low
When mulching, piles of grass are left
behind the mower
Grass is wet
2 x swing blades (30) are dull or blunt
Rear discharge chute (16) is blocked
Increase the cutting height using the
8 height adjustment lever (18)
Lift the height of the cutting depth by one
notch using the 8 height adjustment lever (18)
Allow the grass to dry before mowing
Sharpen or replace the 2 x swing blades (30)
Stop mower and clear the rear discharge
chute (16)
Troubleshooting.
Service Support
If you have any issues with the operation of your product, please take it with a copy
of your receipt to one of our National Service Agents for repair. A listing of our Service
Agents is included with your product, however, you can also nd our most updated
listing by visiting powertoolsupport.com, and clicking on the Service Agent link.
Alternately call us on our Customer Support line, 1800 909 909, for advice or support.
To Next Page
Loading...
