Start-up
13
− Connect the paint spray system only if the mains voltage of the socket
corresponds to the type plate specification.
− Connect the paint spray system only to an easily accessible socket so that
you can quickly disconnect it from the mains supply in case of a fault.
− Never touch the paint spray system or the mains plug with damp hands.
− Lay the connection cable so that it does not pose a tripping hazard.
− Do not kink the connection cable and do not lay it over sharp edges.
− Before working on the paint spray system, pull the mains plug out of the
socket.
− Cover all surfaces and objects you do not intend to spray or remove them
from the work area. When working with the paint spray gun, please note
that e.g. wind can blow paint mist over considerable distances and inflict
damage as a result.
− Only use the spray adapter with a functional valve.
− Stop operating the paint spray system if the paint rises into the ventilation
hose. Remove the ventilation hose, valve and membrane, clean them and
replace the membrane if necessary.
− If the mains connection cable of this paint spray system is damaged, it
must be replaced by the manufacturer, its After Sales Support or a similarly
qualified person in order to prevent risks.
Start-up
Checking the paint spray system and package contents
NOTICE!
Risk of damage!
If you open the packaging with a sharp knife or other pointed object without
due care, you can easily damage the paint spray system.
− Be very careful when opening the package.
1. Remove the individual parts of the paint spray system from the packaging.
2. Check that all parts are included (see Fig.A and E).
3. Check for damage to the paint spray system or the individual parts. If there are any
signs of damage, do not use the paint spray system. Contact the manufacturer at
the service address specified on the warranty card.
To Next Page
Loading...
