Start-up
16
Fitting/changing the spray unit
CAUTION!
Risk of injury!
Improper handling of the paint spray system can cause injury.
− Only connect the paint spray system to a socket when it has been com-
pletely assembled and filled with paint.
Fitting the spray unit to the motor unit
1. Fold the locking handle
18
on the motor unit
2
as far down as it will go (see Fig. A).
2. Place the spray unit required
9
or
11
in the holder of the motor unit in such a
way that the line marking on the spray unit points to the line marking next to the
symbol on the motor unit (see Fig. B).
3. Turn the motor unit 90° clockwise until it stops.
The line marking on the spray unit must be pointing to the line marking next to
the
symbol on the motor unit.
4. Fold the locking handle back up so that it engages audibly in the hooks on the
spray unit.
Removing the spray unit from the motor unit
1. Fold the locking handle
18
on the motor unit
2
as far down as it will go (see Fig. A).
2. Rotate the motor unit 90° anticlockwise so that the line marking on the spray unit
points to the line marking next to the
symbol on the motor unit (see Fig. B).
3. Remove the spray unit from the motor unit from the front.
To Next Page
Loading...
