Start-up
14
Selecting the material and spray unit
NOTICE!
Risk of damage!
Materials that are not permitted for use may damage the paint spray system.
− Take note of the list of materials that are permitted and not permitted for use.
Permissible materials Impermissible materials
• Indoor wall paint (dispersions etc.) • Lyes, acid-containing coating
agents
• Solvent-based and water-based
paints
• Flammable coating agents
• Glazes, primers
• 2-component lacquers, clear coats
• Vehicle top coats
• Stains and wood preservatives
NOTICE!
Risk of damage!
Improper handling of the paint spray system can cause damage.
− Thin the paint if necessary. Refer to the information from the manufactur-
er regarding sprayable thinners.
− Perform a trial with the paint spray gun to determine the best level of
thinning.
− Refer to the reference values provided in the table if you are unable to
find corresponding manufacturer information.
− If the flow rate is too low, gradually add thinner in an amount of 5 – 10% until
you reach the necessary flow rate. Observe the maximum permissible level of
thinning according to the information provided by the manufacturer.
− Stir the material thoroughly and thin it in the paint container based on the
recommended level of thinning.
To Next Page
Loading...
