ALDI FERREX 300W - Operation; Getting Started; Finishing Work

300W multifunctional tool
16
GB IRE
www.coreservice.co.uk
AFTER SALES SUPPORT
IRE
GB +44 (0) 1904 727501
+353 (0) 19022605
Operation
Getting started
1. Make sure that the multifunctional tool has been properly prepared as described
in the chapter “Preparing the multifunctional tool”.
2. Connect the multifunctional tool to a mains socket.
3. Switch the extractor on.
4. Use the On/Off switch
3
to switch the multifunctional tool on. (see fig. H)
5. Use the speed control
4
to adjust the speed. (see fig. I) Set the speed control
to level 1 for low vibration (oscillation) and to level 6 for intense vibration
(oscillation). Make sure that you use the correct speed for the work material or
test various speeds on the work material to determine the correct one.
6. Hold the multifunctional tool up to the work piece. You can now process the
work piece.
Finishing work
1. Take the multifunctional tool out of the work piece.
2. Use the On/Off switch
3
to switch the multifunctional tool off.
3. Pull the mains plug out of the socket.
Operation