ALDI FERREX 705715 - Operating instructions; Mounting to a bench; Switching on and off; Sharpening HSS drill bits

AFTER SALES SUPPORT
(toll free)
65 W Multifunctional sharpener
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL No.: BDS651 • 05/2021 • 705715
NOTE: Before using the sharpener, read the instruction manual carefully.
Mounting to a bench
NOTE: There are four bench mountable holes (15)
on the base of the sharpener. Use four screws (not
provided) to x it onto a stable position before use.
Switching on and o
1. Insert the plug into the mains power socket and
switch on the power.
2. To turn the sharpener on, move the on/o switch
(10) to the “I” position.
3. To turn the sharpener o, move the on/o switch
(10) to the “O” position (See Fig. A).
Sharpening HSS drill bits
WARNING: Before assembling the HSS drill
sharpener module (2) , be sure the sharpener
is unplugged and the on/o switch (10) is in
the O “O’’ position.
1) Slide the HSS drill sharpener module onto the side of the sharpener with
the grinding wheel (1). Make sure the HSS drill sharpener module is locked
in place (See Fig. B1, B2).
Operating instructions
A.
B4.B2.
13 mm
3 mm
B3.
B1.
10