ALDI Ferrex 706193 - Using the Engraver; Engraving Tip Material Warning

13W Engraving Tool
9
AU
AFTER SALES SUPPORT
(toll free)MODEL No.: PER13G1.A • 07/2021 • 706193
e-mail: info.aldi@positecgroup.com
1300 889 028
AU
2) Connect the engraver power cord (6) to the power supply and hold the
engraver rmly.
3) To turn the engraver on, press the on/o switch (3).
4) Hold the machine in a vertical position (almost 90°to the workpiece).
Try to execute individual lines in one uniform movement without
stopping if possible as later on it will be possible to make out paused
and uneven movements on the engraved workpiece. Sketch out the
outlines on the workpiece prior to engraving if necessary (e.g. with
the aid of the stencils provided. It may also assist to clamp down the
stencil onto the work piece to sketch the outlines) in order to make it
possible to engrave more even lines.
NOTE: Do not press down hard while engraving, use light pressure
while guiding the point over the work to be completed.
WARNING! The supplied engraving tip (1) is made of tungsten
steel. It is therefore not suitable for engraving electronic media
such as CDs, DVDs, etc. These materials and their readability could be
damaged.