ALDI Ferrex 706193 - Maintenance; Replacing the Engraver Tip

To Next Page

To Previous Page

13W Engraving Tool

AFTER SALES SUPPORT

(toll free) MODEL No.: PER13G1.A • 07/2021 • 706193

e-mail: info.aldi@positecgroup.com

1300 889 028

Maintenance

Replacing the engraver tip

Change the engraving tip as soon as it becomes worn and no longer

delivers the desired engraving results.

WARNING! Disconnect the engraver from the power supply before

making any adjustments or undertaking maintenance procedures.

1) Remove the protection cap (a) from the engraver tip (1). (Fig. A1)

2) Loosen the tip release cap (2) by turning it anti-clockwise and then

remove it from the engraver. (Fig. C1)

3) Remove the spring and washer from the engraver tip and then remove

the engraver tip (1). (Fig. C2, C3)

4) To t the new engraving tip (not supplied), slide the washer and spring

onto a new engraving tip rstly. Then insert the new tip through the

centre of the hole of the engraver, ensuring the tip fully enters the

housing.

3) Tighten the tip release cap (2) fully by rotating it in a clockwise

direction.