Pack contents / parts
Congratulations on the purchase of your Ferrex® 13W Engraving Tool. When
you open your packaging, rst remove all items and check there are no parts
damaged or missing. If you nd anything wrong, do not operate the product
until the parts have been replaced or the fault has been rectied.
Failure to do so could result in serious personal injury.
First time users or inexperienced operators pay particular attention to
the operation of the 13W Engraving Tool, including details of starting and
stopping and correct use of the 13W Engraving Tool on pages 8-9, as well as
the maintenance instructions on pages 10-11.
Intended use of the 13W Engraving Tool
NOTE: This product is for private domestic DIY use only.
It is not suitable for commercial or trade use.
This 13W Engraver is used for engraving or decorating all kinds of exible
materials, for example; soft metal, ceramic, glass, wood or plastics and stone.
The tool is to be used only for its prescribed purpose. Any other use is
deemed to be a case of misuse.
Contents of carton
1 x Engraving tool
1 x Tungsten carbide tip
4 x Templates
1 x Instruction manual
1 x Warranty card
2
To Next Page
Loading...