ALDI Ferrex 706193 - FAQ and Troubleshooting; Stroke Adjustment Dial Function; Troubleshooting Common Faults

13W Engraving Tool
13
AU
AFTER SALES SUPPORT
(toll free)MODEL No.: PER13G1.A • 07/2021 • 706193
e-mail: info.aldi@positecgroup.com
1300 889 028
AU
Fault Cause Remedy
Engraving too deep or
too shallow.
The depth of
engraving is not set
properly.
Adjust the stroke
adjustment dial (4) to a
proper position.
Engraving tip (1) loosen
or detached.
Tip release cap (2)
not tightened.
Tighten the tip release
cap (2).
For other issues not covered in this chart, please call Customer Service on
1300 889 028.
FAQ/Troubleshooting
Troubleshooting
Frequently Asked Question
1. What is the function of the stroke adjustment dial?
The stroke adjustment dial (4) located on the top of the engraver, controls the
stroke length and therefore the depth of engraving.
2. What do I do if I have an issue with my 13W Engraving Tool?
If you have any issues with your 13W Engraving Tool, please contact our
Customer Service line on 1300 889 028.
For further inquiries or issues associated with your 13W Engraving Tool ,
call our Customer Service on 1300 889 028 or email us at
info.aldi@positecgroup.com.