ALDI Ferrex 706193 - Cleaning and General Inspection; Storage and Residual Risks

13W Engraving Tool
11
AU
AFTER SALES SUPPORT
(toll free)MODEL No.: PER13G1.A • 07/2021 • 706193
e-mail: info.aldi@positecgroup.com
1300 889 028
AU
WARNING! Always ensure that the Engraver is switched o and
the plug is removed from the power point before making any
adjustments or undertaking maintenance procedures.
1) Use a soft brush to remove any accumulated dust. Wear safety glasses
to protect your eyes whilst cleaning.
2) If the body of the engraver needs cleaning, wipe it with a soft damp
cloth. A mild detergent can be used but never alcohol, petrol or other
harsh cleaning agents.
3) Never use caustic agents to clean plastic parts. Keep the motor
ventilation slots clean.
Caution: Water must never come into contact with the engraver.
General inspection
Regularly check that all the xing screws are tight. They may vibrate loose
over time.
WARNING! Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
There are no user serviceable parts in your Engraving Tool. Never use water
or chemical cleaners to clean your Engraving Tool. Wipe clean with a dry
cloth. Always store your Engraving tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally
you may see sparks through the ventilation slots.
This is normal and will not damage your Engraving Tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
Storage
Store in a secure, dry place out of the reach of children. Do not place
other objects on the product.
Residual risk
Even if you use the 13W Engraving Tool properly per the instructions
provided and following all safety notes, there are always residual risks. The
following risk may occur:
- Accidental Starting: Always remove the plug from the socket
before carrying out any adjustment, servicing or maintenance. When
not in use, store the device in a safe, dry, clean environment.
Reduce residual risks by using the 13W Engraving Tool with care and
following all safety notes as well as other instructions.