Pack contents / parts
Congratulations on the purchase of your FERREX® 3.6V Li-ion Screw-
driver. When you open your packaging, rst remove all items and check
there are no parts damaged or missing. If you nd anything wrong, do
not operate the product until the parts have been replaced or the fault
has been rectied. Failure to do so could result in serious personal injury.
Application
First time users or inexperienced operators pay particular attention to
the operation of the 3.6V Li-ion Screwdriver, including details of starting
and stopping and correct use of the 3.6V Li-ion Screwdriver on pages
10-12, as well as the maintenance instructions on pages 12.
Intended use of 3.6V Li-ion Screwdriver
NOTE: This product is for private domestic DIY use only. It is not suitable
for commercial or trade use.
This 3.6V Li-ion Screwdriver can be used for fastening or removing
screws on wood, metal, plastic and other materials.
The 3.6V Li-ion Screwdriver is to be used only for its prescribed purpose.
Any other use is deemed to be a case of misuse.
Contents of carton
• 1 x 3.6V Screwdriver
• 24 x 25mm Screwdriver bits
• 1 x 60mm magnetic bit holder
• 1 x 50mm PH2 impact bit
• 1 x USB charging cable
• 1 x Instruction Manual
• 1 x Warranty Card & Details
2
To Next Page
Loading...
