ALDI FPHS 3.6Va - Fitting Screwdriver Bits; Use; Switching on and off

27
Use
Fitting screwdriver bits
Warning! Set the changeover switch (4) to its center
position whenever you carry out any work (for exam-
ple changing the bit, maintenance, etc.) on the cord-
less screwdriver.
• Push the tool holder sleeve
forward and hold it (9).
• Insert the bit (13) in the tool
holder (8) and release the
tool holder sleeve (9).
• Check that the bit is locked
in placed by pulling on it.
NOTICE!
54 screwdriver bits are included in the set. When pur-
chasing additional bits, make sure that they have
a
1
/
4
" (6.35 mm) hexagonal shaft.
Use
Switching on and off
To switch on: Press the
On/Off switch (5).
To switch off: Release the
On/Off switch.
5
9
8
FX-5902183-5902184-Bedien-2002.indd 27FX-5902183-5902184-Bedien-2002.indd 27 18.05.20 15:4518.05.20 15:45