29
Use
If the setting is correct, the friction clutch is triggered
when the screw head is flush with the workpiece. The
ideal torque can be best determined using a piece of
excess material.
• Match the desired torque
(1 – 7) on the setting
scale (10) of the machine
housing with the setting
mark (10a).
Operating information
Generally speaking, screwdriver bits are labelled with
their dimensions/sizes and shape. If you are unsure,
check by hand whether the bit fits into the screw head
without play.
Tip:
It is possible to install screws with a ground thread into
softwood without pilot drilling. Pilot drilling is recom-
mended for other woods or when using large screw
diameters.
You will need to countersink the hole for countersunk
screws.
10
10a
FX-5902183-5902184-Bedien-2002.indd 29FX-5902183-5902184-Bedien-2002.indd 29 18.05.20 15:4518.05.20 15:45
To Next Page
Loading...
