Safety information
10
− After transporting the device, wait until it has reached ambient
temperature before switching it on.
Power supply
• Only operate the protection class II device on a 220-240 V~,
50/60 Hz earthed power socket that is close by and easy to ac-
cess, or by inserting 4x 1.5 V, R20/LR20/D batteries into the bat-
tery compartment.
DANGER!
Risk of electric shock!
Even when the device is switched off, some components are live.
In order to interrupt the power supply to your device or to com-
pletely disconnect the device from any power source, pull the
mains plug out of the socket and remove the batteries from the
device.
• Make sure that the mains cable does not present a trip hazard.
The mains cable must not be trapped or pinched or run across
hot surfaces.
• Before cleaning, pull the plug out of the mains socket.
DANGER!
Risk of electric shock!
The device contains live parts. They pose a risk of electric shock or
fi re if an unintentional short circuit occurs.
− Never open the housing and never insert any objects through
the slots and openings into the device!
• Do not place any objects on the cable as this may damage it.
• Keep the device at a distance of at least one metre from sources
of high-frequency or magnetic interference (televisions, speak-
ers, mobile telephones etc.) to avoid malfunctions and data loss.
IMA 43386 Content V2.2.indd 10IMA 43386 Content V2.2.indd 10 04.06.2021 10:45:1004.06.2021 10:45:10
To Next Page
Loading...