15
AFTER SALES SUPPORT
1300 855 831
support@scheppach.com.au
MODEL: HBS20 PRODUCT CODE: 60339 04/2018
AUS
HBS20 Safety regulations
rials similar to wood, or plastics.
– If connections for dust extraction and a collecting device are present, make
sure that they are connected and used properly.
– When processing wood, materials similar to wood, and plastics. operation in
enclosed spaces is only permitted with the use of a suitable extraction system.
11 Secure the workpiece
– Use the clamping devices or a vice to hold the workpiece in place. In this
manner, it is held more securely than with your hand.
– An additional support is necessary for long workpieces (table, trestle, etc.) in
order to prevent the machine from tipping over.
– Always press the workpiece rmly against the working plate and stop in order
to prevent bouncing and twisting of the workpiece.
12 Avoid abnormal posture
– Make sure that you have secure footing and always maintain your balance.
– Avoid awkward hand positions in which a sudden slip could cause one or both
hands to come into contact with the saw blade.
13 Take care of your tools
– Keep cutting tools sharp and clean in order to be able to work better and more
safely.
– Follow the instructions for lubrication and for tool replacement.
– Check the connection cable of the electric tool regularly and have it replaced
by a recognised specialist when damaged.
– Check extension cables regularly and replace them when damaged.
– Keep the control panel and micro switch dry, clean and free of oil and grease.
14 Pull the plug out of the outlet
– Never remove loose splinters, chips or jammed wood pieces from the running
saw blade.
– During non-use of the electric tool or prior to maintenance and when replacing
tools such as saw blades, bits, milling heads.
– When the saw blade is blocked due to abnormal feed force during cutting, turn
the machine off and disconnect it from power supply. Remove the work piece
and ensure that the saw blade runs free. Turn the machine on and start new
cutting operation with reduced feed force.
15 Do not leave a tool key inserted
– Before switching on, make sure that keys and adjusting tools are removed.
16 Avoid inadvertent starting
– Make sure that the switch is switched off when plugging the plug into an outlet.
17 Use extension cables for outdoors
To Next Page
Loading...
Need help?
General
