16
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: HBS20 PRODUCT CODE: 60339 04/2018
AUS
Safety regulations HBS20
– Only use approved and appropriately identied extension cables for use out-
doors.
– Only use cable reels in the unrolled state.
18 Remain attentive
– Pay attention to what you are doing. Remain sensible when working. Do not
use the electric tool when you are distracted.
19 Check the electric tool for potential damage
– Protective devices and other parts must be carefully inspected to ensure that
they are fault-free and function as intended prior to continued use of the elec-
tric tool.
– Check whether the moving parts function faultlessly and do not jam or whether
parts are damaged. All parts must be correctly mounted and all conditions must
be fullled to ensure fault-free operation of the electric tool.
– The moving protective hood may not be xed in the open position.
– Damaged protective devices and parts must be properly repaired or replaced
by a recognised workshop, insofar as nothing different is specied in the op-
erating manual.
– Damaged switches must be replaced at a customer service workshop.
– Do not use any faulty or damaged connection cables.
– Do not use any electric tool on which the switch cannot be switched on and off.
20 ATTENTION!
– The use of other insertion tools and other accessories can entail a risk of injury.
21 Have your electric tool repaired by a qualied electrician
– This electric tool conforms to the applicable safety regulations. Repairs may
only be performed by an electrician using original spare parts. Otherwise acci-
dents can occur.
22 Do not use the cable for purposes for which it is not intended.
– Do not use the cable to pull the plug out of the outlet.
– Protect the cable from heat, oil and sharp edges.
Additional safety instructions
• Wear safety gloves whenever you carry out any maintenance work on the blade!
• When cutting round or irregularly shaped wood, use a device to stop the work-
piece from twisting.
• When cutting boards in upright position, use a device to prevent kick-back.
• A dust extraction system designed for an air velocity of 20 m/s should be con-
nected in order to comply with woodworking dust emission values and to ensure
reliable operation.
To Next Page
Loading...
Need help?
General
