HMSOMP Safety
regulations/Before
starting the
l5 Keep unused
batteries
in the original
packaging
and keep them away from
metal
objects Do not
mix
unpacked batteries
or
toss
them together! This
can
lead
to a short-circuit of the battery and thus damage, burns or even the risk of fire.
l6
Remove batteries from the equipment when it will not be used for an extended
period
of time,
unless it is for emergencies!
17 NEVER handle batteries that have leaked without appropriate
protection
lf
the leaked fluid comes into contact with
your
skin, the skin in this area should
be
rinsed
off
under running water immediately. Always
prevent
the fluid from
coming into contact with the eyes and
mouth.
ln the event of contact,
please
seek immediate medical attention
18 Clean the battery
contacts
and corresponding
contacts in the device
prior
to
inserting
the
batteries:
Residual
risks
The
machine has been built according to the state of the art and the recog-
nised
technical safety reguirements. However, individual residual risks can
arise during operation.
.
Health hazard due to electrical
power,
with the use of improper electrical con-
nection
cables
.
Furthermore, despite all
precautions
having been
met,
some
non-obvious
resid-
ual risks may still remain
.
Residual risks can be minimised if the
"safety
instructions" and the
"Proper
use"
are observed along with the whole of the operating instructions.
.
Do not load the machine unnecessarily: excessive
pressure
when
sawing will
quickly
damage the saw blade, which results in reduced output of the machine in
the
processing
and
in cut
precision.
.
When cutting
plastic
material,
please
always
use
clamps:
the
parts
which
should
be
cut must always be fixed between the clamps
.
Avoid accidental starting of the machine: the operating button may not be
pressed
when inserting the
plug
in an outlet.
.
Use the tool that is recommended in this manual
ln
doing so,
your
mitre saw
pro-
vides optimal
performance.
.
Hands may never enter the
processing
zone when
the
machine is
in operation.
Release the handle button and switch off the machine
prior
to any operations.
Vl.
Before starting the equipment
o
The equipment
must
be
set
up where
it
can
stand
securely, i.e. it should be bolt-
ed to a workbench, a universal base frame or similar. To do this, use the holes
located in the frame of the machine.
r
All covers and safety devices have to be
properly
fitted before the
equipment
is
switched on
.
lt must be
possible
for the blade to run freely
AFTER
SALES SUPPORT
E su
pport@scheppach.com.au
MODEL:HM80MP PRODUCT
CODE. 53666 06/2017
19
t
^*
1300
855 831
To Next Page
Loading...
