HMSOMP
Attachment and
7.4 Changing the speed
(Fig.
2)
The saw has 2 speed ranges:
.
To operate the
saw
at a speed
of 3800
rpm
(non-ferrous
metals), set the switch
(42)
to
position
l.
.
To operate the saw at a speed of 5000 rpm
(wood),
set the switch
(42)
to
posi-
tion ll
7.5 Cross cut 90o and turntable 0'
(Fig.1,2,6,7)
ln the case of cutting widths up to
approx.
''100
mm it is
possible
to fix the traction
function of the
sawwith
the locking
screw
(23)
in the
rear
position
ln this
position
the machine can be operated in cross cutting mode lf the cutting width
is over
100 mm then it is necessary to ensure that the locking screw
(23)
is loose
and the
machine head
(5)
can move.
Caution!
For
90'
mitre
cuts, the moveable fence
(28)
must be fixed in the inner
position.
r
Open the set screw
(29)
on the moveable fence
(28)
and
push
the moveable
fence
(28)
inwards.
.
Warning!
The moveable
fence
(28)
must
be
locked in a
position
far enough
from the inner
position
that
the distance
between the fence
(28)
and the saw
blade
(7)
is no more than 5 mm
.
Before making the cut, checkthat no collision could occur
between the fence
(28)
and the saw blade
(7).
.
Tighten the set screw
(29)
again
e
Move
the
machine head
(5)
to its upper
position.
.
Use the handle
(1)to
push
back
the
machine head
(5)
and
fix
it in this
position
if
required
(dependent
on the
cutting width).
.
Place
the
piece
of
wood to be
cut at the
fence
(18)
and on the turntable
(16).
.
Lock the material with the clamping
device
(8)
on the fixed
saw table
(16)
to
pre-
vent the material from moving during the cutting operation.
.
Push down the release lever
(3)
to release the machine
head
(5).
.
Press the ON/OFF switch
(2)
to start the motor
r
With
the drag
guide
(23)
fixed in
place:
use the handle
(1)to
move the
machine head
(5)
steadily and with light
pressure
downwards until the saw blade
(7)
has completely cut through
the
work
piece.
o
With the drag
guide
(23)
not fixed in
place:
pull
the machine head
(5)
all
the way to the
front
Lower the handle
(1)
to the
very bottom by applying steady and light downward
pressure.
Now
push
the ma-
chine head
(5)
slowly and steadily
to
the very back
until the saw blade
(7)
has
completely cut through the work
piece.
r
When the cutting operation is completed,
move
the machine head
(5)
backto its
upper
(home)
position
and release the ON/OFF button
(2).
Caution! The machine executes
an upward
stroke automatically
due to the re-
turn spring, i.e. do not release the
handle
('1)after
completing the cut; instead
AFTER
SALES SUPPORT
E support@scheppach.com.aLt
MODEL:HMSOMP PRODUCT
CODE: 53666 06/2017
21
t
*'
1300 855 831
To Next Page
Loading...
