10
MULTIPLE BABY UNITS
After you have purchased loose baby units (DBX-93) you can set up multiple
babies ‘monitoring’. Ensure that the baby units and the parent unit are connected
on the same channel and sub-channel. In case this does not work, you can also
choose an alternate monitoring, see below:
ALTERNATE MONITORING OF 2 BABY UNITS:
Baby units:
1. Set the two baby units on dierent channels (the sub-channel setting may be
selected too)
Parent unit:
1. First set the parent unit to the same channel and sub-channel as the 1st baby
unit, press the
PTT
button to conrm the setting.
2. Now push 7x on the button and by using the button or the button
select the channel of the 2nd baby unit (select [OFF] to disable this feature).
3. Push 1x on the button and using the button or the button select the
sub-channel of the 2nd baby unit.
4. Push the
PTT
button, the parent unit will now alternately listen between baby
unit 1 and baby unit 2.
ALTERNATE MONITORING OF MORE THAN 2 BABY UNITS:
Baby units:
1. Set the baby units to dierent channels (set the sub-channel settings to 00)
Parent unit:
1. Push the button and button simultaneously, this enables the parent
unit to consecutively listen to all the channels.
2. When the parent unit picks up sound from one of the channels it will stop
scanning and transmit only the signal from that camera. The parent unit will
continue scanning a few seconds after the sound has stopped.
- Push the button to continue scanning if only noise or an unwanted channel
is received on the signal.
- Push the
PTT
button to end the scanning function.
10
To Next Page
Loading...
Need help?
General
