To Next Page

To Previous Page

SOUND ALERT:

You can set the baby unit to send an alert tone rst before a transmission is sent.

The alert signal will be di󰀨erent from any other signals you receive.

Only baby unit:

1. Push on the

button 5x; the word [CA] will then light up.

2. Push on the button to turn the function [ON] in the display or push the

button to turn the function [OFF] on the display.

3. Push the

button to set the selected function.

Note: These sounds are NOT added to the beeps sent for the purpose of con-

nection control.

KEYPAD LOCK:

To avoid accidentally changing the channel on the parent unit or turning the

volume too low, you can lock the keypad in the following way:

Only parent unit:

1. Push on the () button until the icon lights up in the display.

2. To unlock it, push the () button again until the icon disappears from the display.

The buttons , and will be blocked when the icon lights up on the

display.

STOPWATCH:

The parent unit is equipped with a stopwatch function,

1. Push on the button for 3 seconds to turn on the stopwatch

- Push the button to start the stopwatch

- Push the button for the laps time (the time will continue to run)

- Push the button to continue

- Push the button to set the stopwatch at 00:00

2. Push the button for 3 seconds to turn o󰀨 the stopwatch

During this mode, the baby monitor function on the parent unit will still be active.

KEYPAD TONE:

When you push a button on the parent unit a beep tone will sound. You can

switch the beep tones on or o󰀨 using the following steps:

1. Push the button 6x; [ONto] or [OFFto] will then ash on the display.

2. Push the button to switch the beep tone function [ON] in the display, or push

the button to deactivate the function [OFF] in the display.

3. Push the

PTT

button to set the selected function.

Alecto DBX-92 User Manual

Questions and Answers: