To Next Page

To Previous Page

CONNECTION CONTROL:

Every 30 seconds, you can send three short beep tones from the baby unit to the

parent unit. This enables the connection to be checked every 30 seconds. This

function can be switched on or turned o󰀨 as follows:

Baby unit only:

1. Push 3x on the button

; the word [BEEP] will light up.

2. Push on the button to turn this function [ON] in the display or push on the

button to turn this function [OFF] in the display.

3. Push on the

button to set the selected function.

MONITORING: (forced listening)

Baby unit:

You can set the baby unit so that it broadcasts every 5 minutes for 5 seconds,

even when the baby unit does not detect sound.

1. Push 4x on the

button; the word [AUTO MON] will light up.

2. Push the button to turn this function ([ON] in the display) or press the

button to turn this function [OFF] in the display.

3. Push on the

button to set the selected function.

Parent unit:

You can temporarily or permanently disable the noise reduction of the parent unit

so you can still hear the baby unit when a weak signal is received.

- Push on the button to switch o󰀨 the noise reduction, when you release this

button, the noise reduction will be switched on again.

- If you push and hold the button for more than 3 seconds, you will hear a

short beep sound which will indicate that the continuous noise reduction has been

turned o󰀨. If you release the button you can continue to listen for a short

time. Push the button to turn the noise reduction on again.

Alecto DBX-92 User Manual

Questions and Answers: