4
INSTALLATION
BABY UNIT:
The baby unit is powered from the supplied xed power adapter. The power
adapter can be connected to a 230V electrical outlet.
Place the baby unit in the nursery. It is recommended to keep the baby and the
baby monitor at a minimum distance of 2 meters. Ensure that the baby cannot
touch the baby monitor or the power adapter cord.
The baby unit can also be mounted on the wall. There is an opening for mounting
located at the back of the baby unit.
PARENT UNIT:
The parent unit is powered by an included NiMH battery pack (4.8V). The parent
unit is not xed to a power adaptor so it can be used cordless.
Connect the power adapter to the parent unit, and then plug the power adapter
into a 230V 50Hz electrical outlet.
Please note that the battery pack needs about 14 hours in order to fully charge.
1
2
3
1. Take o the belt clip 2. Open the battery
compartment located
on the bottom of the
unit by clicking open
the cover
3. Place the battery pack
into the battery com-
partment as indicated
and close the cover.
4
To Next Page
Loading...
