10. Sound a nd L i ght i ndic at i on
Operation Status
Zone1 unlock
Zone2 unlock
Power on
Operation successful
Operation failed
Enter into programming mode
Red Light
-
-
Bright
Shines
slowly
-
-
Green Light
Bright
-
-
-
-
-
-
Blue Light
-
Bright
-
-
-
-
Bright
Buzzer
Short Ring
Short Ring
Long Ring
-
Short Ring
Long Ring
Press keypad
-
Bright
-
-
-
-
3 Short Rings
Long Ring
11 et ailed Pr ogr ammi ng Guide
Stand by
In the programming mode
Exit from the programming mode
Alarm
Bright Bright - -
Shines
slowly
Shines
quickly
-
-
-
- Long Ring
Alarm
11.1 User Settings
To exit from the programming mode
To enter the programming mode
Note: All the steps below must be done after entering into the programming mode
Master code
#
888888 is the default factory master code
8. Reset t o Fac t or y Def au l t
9. Ant i Tam p er A l ar m
The ses a LDR (light dependent resistor) as
an anti tamper alarm. If the keypad is removed from the
cover then the tamper alarm will operate.
To reset to factory default, power off, press * , hold it and
power on, release it until hear three beeps(two short, one
long), means reset to factory default successfully.
Remarks: Reset t o factory default, the user’ s information is
still retained.
LM178
LM178
To Next Page
Loading...