www.aleratec.com
44
Using the DVD/CD Duplicator
Main Menu
Advanced Setup - continued
12.06 Burn-in
Burn-in is a test function. You can set up to test continuously or for a specied
number of cycles.
Load Blank DVD/CD media in the DVD/CD-Recorder and a source disc in 1.
the DVD/CD-ROM drive. The copy process will be simulated, but data will
not be written to the target discs.
Note: Burn In is not supported by DVD+R/RW discs.
Go to Burn-in and press the 2. ENT button to enter. You can select Test to
simulate duplication of DVDs/CDs or Erase and Copy to test DVD/CD-RW
erase and write. Use the arrow key to select Continuous or the number of
test cycles you want to run. Press the ENT button to start the test, or ESC to
go back to manual operation.
Select “Erase&Copy” to test erasing and rewriting to DVD/CD-RW discs 3.
only.
Burn-in
Test
ESCENT
12-06. Adv Setup
Burn-in
ESCENT
Set Burn-in num:
Run Continuous
ESCENT
Burn-in
Erase&Copy
ESCENT
To Next Page
Loading...
