22
2) Pressing the "Up" PAGE button will select the next page which will read:
RING MOD OUTPUT
MIX: DOWN<-00->UP
Pressing the VALUE buttons will select the desired mix of Up to Down Ring
Modulator outputs.
3) Pressing the "Up"
PAGE button again will select the third page which will read:
DEL/REVERB INPUT
MIX: DOWN<-00->UP
Pressing the VALUE buttons will select the desired ratio of Up to Down
Spectrum Shift which can then be used as input for the Delay or Reverb.
This differs from the second page in that it is possible to send a different
mix of Ring Modulator outputs to the Delay and Reverb than the mix that
will appear in the
MIX section of the QuadraVerb Plus.
MODULATING THE RING MODULATOR
PARAMETERS
The Spectrum Shift, Ring Modulator Output up/down mix, and Delay/Reverb
up/down mix can also be modulated by any MIDI modulation source. This can
be accomplished by referring to the "Modulating the Parameters" section of the
QuadraVerb Users Manual on page 66.
EDITING THE DELAY AND REVERB
PARAMETERS
The parameters and mode of adjustment of the Delay and Reverb sections are
identical to the original LEZLIE-> DELAY->REVERB configuration as found on
page 69 of the QuadraVerb Users Manual.
RESONATORS
Instead of just processing a signal such as Delay or Reverb, a resonator
generates a pitch in addition to the original input signal. There are 5 resonators
in the QuadraVerb Plus. The initial resonating frequency of each resonator can
be individually adjusted (tuned) on a chromatic scale. The resonator frequencies
also chromatically follow incoming MIDI notes. The decay time of the five
resonators can also be adjusted simultaneously.
To Next Page
Loading...