Recording
6 4 STUDIO 24 REFERENCE MANUAL
To bounce multiple tracks to two tracks (stereo):
1 For each Channel (tape track) you wish to bounce, press the CHAN/MON
REVERSE button so it is down.
This sends the tape tracks to the Channel FADERS.
Make sure that CHAN/MON REVERSE is UP on the Channels you’re
bouncing to (Channels 5 and 6 in this example). Otherwise, feedback
may occur.
2 Assign the Channels to Groups 1 and 2 by pressing the GRP buttons next to the
channel faders.
3 Raise the GRP 1 and 2 FADERS to the maximum position.
4 Place tracks 5 and 6 into record-ready, and select either GRP 1/2 or MON 1/2 as
the Control Room source. If you’re using MON 1/2, turn the monitor pan (the
upper black knob, not the one close to the MUTE key) for track 5 hard left, and
the monitor pan for track 6 hard right.
5 Set the DIRECT OUT SOURCE switch of Channels 5 and 6 to its GRP (down)
position.
6 Adjust each Channel’s PAN knob and FADER to achieve a desirable mix.
7 Rewind the tape, and record onto tracks 5 and 6 those portions you wish to
bounce.
8 Tracks 1-4 are now available for recording new parts.
To Next Page
Loading...
