Specifications
STUDIO 24 REFERENCE MANUAL 9 7
SPECIFICATIONS
All measurements taken with an Audio Precision System One. All noise measurements taken
with trim at minimum and faders at unity gain with 22 Hz to 22 kHz bandwidth unless
otherwise specified. Main In & Out measurements made on balanced +4 dBu connectors. (+4
dBu into a line input with faders at unity and the meter reading “0” will yield +4 dBu into a
balanced load or -2 dBu into an unbalanced load. Unbalanced RCAs at -10dBV (.317 volts))
Subject to change without notice.
FREQUENCY RESPONSE
10 Hz – 75 kHz +0/-1 dB (any input to any output at nominal
operating levels)
-3 dB Point: >125 kHz
CONNECTORS
MIC IN jacks: Female XLR (Pin 1 ground, Pin 2 +,
Pin 3 -)
LINE IN jacks Female 1/4" 3-conductor phone (Tip =
+, ring = -, sleeve = ground)
TAPE IN, DIRECT OUT, 2 TRACK IN jacks: Female RCA
INSERT jacks: Female 1/4" 3-conductor phone (Tip =
send, ring = return, sleeve = ground)
Inserting plug to first "click" allows pre-
fader direct output without breaking
normal signal flow
MAIN OUT (top panel),
CONTROL ROOM OUT, and
AUX SEND jacks: Female 1/4" 3-conductor phone
(Tip = +, ring = -, sleeve = ground)
STEREO AUX RETURN jacks: Female 1/4" 2-conductor, unbalanced
MAIN OUT (rear panel): Female RCA
LEVELS
MIC IN -62 dBu to -12 dBu nominal, maximum
level +11 dBu
LINE IN -42 dBu to +8 dBu nominal, maximum
level +31 dBu (balanced)
TAPE IN -10 dBV nominal, +13 dBV (+15.2dBu)
maximum
MAIN 1/4” OUTPUT LEVELS
(when meter is at 0 VU) +4 dBu (1.24 volts) into a balanced load
-2 dBu into an unbalanced load
MAIN RCA OUTPUT LEVELS -10dBV (.316 volts)
MAXIMUM OUTPUT LEVEL +21 dBu unbalanced, +27 dBu balanced
(5 dB above "PK" segment of main
meter)
HEADROOM 23 dB above nominal output
To Next Page
Loading...
Need help?
General
