ASH 26 E Maintenance Manual
- Disassemble the exhaust silencer and then remove its CFRP fair-
ing so that the exhaust silencer can be visually inspected for dam-
ages. Check the condition of the heat damming material in the
CFRP fairing; if necessary replace.
- Check the elastic rubber coupling between crank shaft and lower
drive pulley for cracks and replace where necessary.
After one year:
- Inspect the engine in accordance with the engine manual.
- Check coolant level and its anti-freeze contents.
- Remove residuals caused by oil, exhaust gases and fuel from po-
wer-plant and engine compartment wherever access is possible
with the power-plant installed.
After three years:
- Inspection and maintenance works as prescribed in the engine
manual.
After five years:
- Replace all rubber fuel hose lines.
Note: According TN 13 the ASH 26 E can be fitted with PUR-
fuel-lines without limited service life, Section 4.2!
b.) Once-Only Maintenance Tasks
After 1 hour and every time the propeller has been reinstalled re-
spectively after 1 hour:
- Check and re-tighten the six mounting bolts of the propeller (ob-
serve the prescribed torque settings given in Section 5.3!).-
Rev.No. / Date Sig.
Page No.
uthor Date
Heide 31.01.95
7.10
TN 1/13 Feb.05 Mü.
To Next Page
Loading...
