Alexander Schleicher ASH 26 E - Page 262

ASH 26 E Maintenance Manual
ASH 26 E POWER-PLANT MAINTENANCE INTERVALS
Engine Hours Period Years Period
Once-only Maintenance after 1 hour:
0 - 150
O
450 - 600
O
1 - 5
O
Retighten M8 bolts at prop.flange
O
150 - 300
O
600 - 750
O
5 - 10
O
300 - 450
O
750 - 900
O
10 - 15
O
Hour Intervals Year Intervals
Wartungsarbeiten nach folgenden Intervallen:
25507510012515012345
Coolant level check
OOOOOO
Retighten propeller bolts
OOOOOO
Check elastic tensioning cords of engine comptmt.doors
OOOOOO
Check guide pulleys
OOOOOO
Clean power-plant (while installed) & engine compartmt.
OOOOOO
Replace fuel filter
OOOOOO
Check fuel hose lines
OOOOOO
Disassemble and clean drainer valve
OOOOOO
Check electric wiring
OOOOOO
Inspect throttle control cables & prop. brake
OOOOOO
Check & adjust idling speed
OOOOOO
Check firm seating of engine mounting bolts
OOOOOO
Check locking wire for the rear engine mounting bolt
OOOOOO
Check gas strut/extending spindle
OOOOOO
Inspect rubber suspension buffers of engine mounting for cracks or other changes
OOOOOO
Check engine compartment door hinges for firm seat or cracks
OOOOOO
Check propeller stop block for function. If required, replace.
OOOOOO
Check & retighten 4 lateral set screws at the propeller head
OOOOOO
Check secure seat of the lock nuts for the 3 tighteners
OOOOOO
Check propeller shaft for radial play in the bearing seatings
OOOOOO
Oil sliding fit of front prop.bearing
OOOOOO
Inspect engine as per engine manual Section 5 Maintenance Schedule
OOO
Check timing belt for wear
OOO
Check belt pulleys for wear
OOO
Check exhaust noise emission during engine ground run
OOO
Inspect engine as per engine manual
O
Inspect belt pulley bearings for play in the ball bearings
O
Inspect engine as per engine manual
O
Disassemble and check exhaust silencer and its CFRP fairing
O
Inspect rubber coupling between crank shaft and lower drive pulley for cracks
O
Inspect engine as per engine manual
OOOOO
Check coolant level and its anti-freeze contents
O
Clean power-plant (while installed) & engine compartment
O
Inspect engine as per engine manual
O
Replace all rubber fuel hose lines (not applicable if PUR fuel lines installed, see section 4.2)
O
Rev.No./Date Sig. Author Date Page No.
TN5/13 Feb. 05 Mü. Heide 31.01.1995
7.11