Alfa Laval ALS Series

Questions and Answers

L
lwhiteAug 11, 2025
Why is my Alfa Laval ALS Industrial Equipment not starting?
- M
  Monique BlevinsAug 11, 2025
  If your Alfa Laval Industrial Equipment is not starting, several factors could be the cause. It could be a defect in the drive unit, in which case you should dismantle the drive unit and check for correct rotation, and replace it if necessary. Another cause could be a fault at the power supply. Check the power supply connection and ensure that the voltage and frequency correspond with the nameplate. Also, check that the frequency converter adjustment corresponds to the nameplate. Finally, an obstructed agitator could be the reason. Ensure the agitator can rotate freely without striking anything.
L
Lori WilsonAug 22, 2025
What to do if the impeller device of Alfa Laval ALS is damaged?
- M
  Mr. Kelly StewartAug 22, 2025
  If the impeller device in your Alfa Laval Industrial Equipment is damaged, it might be due to an unbalanced impeller, in which case you should clean the impeller device. Another possibility is damage to the shaft seal, which would require replacing the sealing. If these are not the cause, contact Alfa Laval.
M
Matthew GutierrezSep 1, 2025
How to resolve oil leakage from the gear in Alfa Laval Industrial Equipment?
- K
  Kelly FloresSep 1, 2025
  If your Alfa Laval Industrial Equipment gear is leaking oil, you should renovate or change the gear immediately. Another possible cause is CIP fluid or other contaminants, in which case you should replace the sealing.

Alfa Laval ALS Series Specifications

General

Material	Stainless Steel
Self-Cleaning	Yes
Flow Rate	Varies by model
Max Tank Diameter	Varies by model
Mounting	Tri-Clamp
Applications	Food, Beverage, Pharmaceutical, Chemical
Capacity	Varies by model
Operating Pressure	0.3 - 1.0 MPa (3 - 10 bar)