Instruction Manual, Gunclean Toftejorg 270FT Mark I Page 19
IM-TE102766-3-EN10
Installation and Normal Operation (continued)
To pre-set pitch angles
1. Turn programming knob to programme 1.
2. With the handle turn first worm screw until the rocker assy rests on the highest point of the cam.
3. Turn the adjusting screw to the point where the rocker starts to lift from the cam. This setting will give
programme 1 a pitch angle of 0°. Turning the adjusting screw down (clockwise) 0.75 revolutions rises the
pitch angle to 1°. Other settings, see table page 20.