3 Installation
Read the instructions carefully and pay special attention to the warnings!
LKH-5 to -60 comes without impeller screw as standard but can be supplied with one.
Check the direction of rotation of the impeller before operation.
- See the indication label on the pump.
S
t
e
p
4
1. Fit pump casing (29).
2.
A. LKH-5: Fit clamps (55+55a), spring washers (56a) and
tighten screws (56)
B. LKH-10 to -60: Fit washers (24a) and tighten cap nuts (24),
according to torque values in chapter 6 Technical data
3000-0220
CONTACT CSI FOR MORE INFORMATION | CSIDESIGNS.COM | SALES@CSIDESIGNS.COM | 417.831.1411
To Next Page