3
It is not necessary to remove old tape as the
film is very thin. Make sure, however, that the
gasket groove is clean and dry.
4
Adhere tape, using the tape gun.
5
Attach the gasket to the plate. Slip the gasket
prongs under the edge of the plate.
6
Close the heat exchanger according to
Closing on page 38.
6.7.3 Glued gaskets
Use glue recommended by Alfa Laval. Separate gluing instructions will be
delivered together with the glue.
CAUTION
Other glues than those recommended can contain chlorides that can
damage the plates.
CAUTION
Do not use sharp tools when removing the glued gasket to avoid damage
to the plates.
200000418-2-EN-GB44
6 MaintenanceEN
To Next Page
Loading...
