Need help?Do you have a question about the alfen Eve and is the answer not in the manual?
General| Brand | Alfen |
|---|---|
| Enclosure Rating | IP54 |
| Impact Resistance | IK08 |
| Mounting | Wall or pole |
| Output Power | 22 kW |
| Input Voltage | 400 V AC |
| Output Voltage | 230 V (1-phase) or 400 V (3-phase) |
| Charging Current | 32 A |
| Charging Connector | Type 2 |
| Charging Capacity | 22 kW |
| Charging Point | Single |
| Connectivity | Ethernet |
| Communication Protocols | OCPP 1.6 |
| Authentication | RFID |
| Protection | Overcurrent, Overvoltage, Short Circuit |
Details electrical safety class, IP54 protection rating, and IK10 mechanical impact resistance.
Specifies nominal input voltages for single and three-phase power, and earthing system requirements.
Lists required system circuit breakers for single-phase and three-phase power supplies.
Specifies cartridge fuse requirements for single-phase and three-phase power connections.
Details optional residual current device specifications for single-phase and three-phase connections.
Provides minimum cable diameter specifications for single-phase and three-phase connections up to 50m.
Instructions for removing the front cover of the Eve unit for installation.
Steps for drilling holes and fitting the mounting bracket for wall installation.
Guidance on positioning and securing the Eve unit to the mounting bracket.
Procedure for installing a SIM card for control management via cellular network.
Instructions for removing and refitting the subframe and plug connection.
Steps for connecting power cables and ethernet cables for control management.
Instructions for refitting the front cover after installation is complete.
Explains LED indicators for charging status: accepted, communicating, active, or error.
Provides contact information for Alfen ICU B.V., including addresses and phone numbers for sales and service.
To Next Page
